Matters needing attention when disassembling rubber O-ring mold:
1. When transporting the mold, pay attention to the upper and lower molds (or fixed and movable molds) in the mold-clamping two hands (one hand supports the upper mold, the other hand supports the lower mold), pay attention to light and stable.
2. Before disassembling and assembling the mold, it is necessary to check whether the tools are normal, and operate according to the safety operating rules of hand tools, and pay attention to the correct use of tools and measuring tools.
3. When disassembling the mold, you should first understand the working performance of the mold, the basic structure and the importance of each part, and disassemble and assemble in order.
4. When using a copper rod or a crowbar to disassemble the mold, the posture must be correct and the force must be appropriate.
5. When using a screwdriver:
a. The screwdriver should not be too thin or narrow, so as not to slip out when tightening the screw.
b. Do not use a screwdriver to tighten the screws with the parts in your hands.
c. Screwdrivers should not be hammered with copper rods or hammers to avoid cracking the handle.
d. The screwdriver cannot be used as a chisel.